CMH10/CMH10D Mechanical Seal

Structural features:

1. Single (or Double) End Face, Set The transmission features evenly distributed force across the multi-spring sealing surfaces. When in use, it is independent of the direction of rotation,

The spring seat, spring, and push ring can be pre-assembled into a single unit for easy installation.

2. Depending on the specific application, auxiliary sealing rings can include rubber O-rings, PTFE V-rings, or PTFE wedge-shaped rings.

3. With its short axial dimension, it can replace skeleton oil seals and is suitable for use in high-speed equipment.

4.CMH10D Type is CM10 A double-end-face design, ideal for sealing applications with higher performance requirements.

Applicable medium:

Oil, water, acids, bases, salts, and more

Note: Since this type of pump has multiple applications, the sealing material (friction pair) also varies. To ensure reliable sealing performance,
The manufacturer recommends the following:
1. Clean water (without particulate matter)—Choose an alloy for the dynamic sealing pair and graphite for the static sealing pair.
2. Highly corrosive conditions (with particulate matter)—select silicon carbide for the moving seal pair, and silicon carbide for the stationary seal pair.
3. Conditions involving particles and significant vibration—select (alloy) for the dynamic ring friction pair, and (alloy) for the stationary ring friction pair.
4. Customization is also available upon customer request. If no specific request is made, the default option will be (clear water).

Work parameters:

Fixed substance content: ≤2%

Warm Temperature: ≤280°C

Press Force: ≤2.5 MPa

Axis Diameter: ≤100mm

Material parameters:
Main material: 304, 316L or 2205, 2507, 1.4529
Sealing ring materials: M106D, YWN8, SSiC or SiC
Rubber material: Fluororubber or perfluoroether rubber

Main applications:

This seal can be used in various types of water pumps and chemical pumps.

Installation Use Requirements :

1. The radial runout of the equipment shaft should not exceed 0.04 millimeters, with axial runout not exceeding 0.1 millimeters;
2. The sealing cavity of the equipment should be kept clean during installation, and sealing components must be thoroughly cleaned. Ensure that the sealing faces remain intact to prevent contaminants and dust from entering the sealing area.
3. During installation, avoid any contact or tapping to prevent damaging the mechanical seal through friction, which could lead to sealing failure.
4. During installation, apply a layer of clean machine oil to the surfaces that will come into contact with the seal, ensuring smooth installation.
5. When installing the stationary ring gland, tighten the screws evenly to ensure the stationary ring face is perpendicular to the shaft centerline.
6. After installation, gently push the moving ring by hand to ensure it moves freely along the shaft while maintaining some elasticity.
7. After installation, manually rotate the shaft—there should be no sensation of unevenness or heaviness.
8. Before starting operation, the equipment must be fully charged with the medium to prevent dry friction, which could lead to seal failure.