Front-mounted pump LTJ-100 HZB253-640 HZB253-H75/110-G115-E1mechanical seal

Material parameters:

Main materials: 2Cr13, 304, 316L, or 2205, 2507

Sealing ring material: M106D, YG8, or SiC

Rubber materials: Fluororubber or perfluoroether rubber

Mechanical seal structural features:

Single-surface, modular, multi-spring, balanced design

Stationary type, externally mounted spring type, flange-mounted type

Applicable medium:

Hot water, boiler water, high-temperature process fluids, and steam.

Work parameters:

Fixed matter content: ≤2%

Warm   Temperature: ≤280°C

Press Force: ≤6 MPa

Axis   Diameter: ≤200 mm

Main applications:

This seal is primarily used for the feed pump upstream of boilers in coal-fired power plants.

Mechanical seal model:

FA1D63 LTJ-8B1D-FA1D63

FA1D56 LTJ-8B1D-FA1D56

FA1D53 LTJ-8B1D-FA1D53

FA1D67 LTJ-8B1D-FA1D67

HZB253-640 LTJ-100

HZB253-H75/110-G115-E1

Installation Use Requirements :

1. The radial runout of the equipment shaft should not exceed 0.04 mm, with axial runout not exceeding 0.1 mm; 
2. The sealing cavity areas of the equipment should be kept clean during installation, and sealing components must be thoroughly cleaned. Ensure that the sealing end faces remain intact to prevent contaminants and dust from entering the sealing area. 
3. During installation, avoid any impact or hammering to prevent damaging the mechanical seal through friction or breakage, which could lead to sealing failure. 
4. During installation, apply a layer of clean machine oil to the surfaces that will come into contact with the seal, ensuring smooth installation. 
5. When installing the stationary ring gland, tighten the screws evenly to ensure the stationary ring face is perpendicular to the shaft centerline. 
6. After installation, gently push the moving ring by hand to ensure it moves freely along the shaft while maintaining some elasticity. 
7. After installation, manually turn the shaft—there should be no sensation of unevenness or heaviness. 
8. Before operating, the equipment must be fully charged with the medium to prevent dry friction, which could lead to seal failure.